What do gurus recommend? Seatools report: - SeaTools for Windows v1.4.0.6 - 7:12:29 PM Model: 42AS Serial: DF8987654321 Firmware: 0 Identify - Started 7:12:29 PM Model: 42AS Serial: DF8987654321 Firmware: 0 Model Number: ST32000542AS Serial Number: 9XW0EZCB Firmware Revision: CC34 Drive Capacity: 0.00 B / 0.00 B Max LBA: 0 Cache Size: - Power-On Hours: 0 Drive Temperature (C/F): 0 / 32 WWN: 5000C5002087D55F Sector size (Logical/Physical/Allignment): 512 / 512 / 0 Rotation rate: 5900 RPM Form factor: - Specification Supported: ATA8-ACS Encryption Support: Not Supported Security Mode: Supported SMART: Enabled Host Protected Area features: Enabled Advanced Power Management: Enabled Download Microcode: Segmented I know electronics and I had a couple of project involving serial communications but I am not an expert. I feel I can perform the second task but the explanations I have found were a bit scarce and missing some schematics. Would it work? What special step? Or connect through serial port and attempt to reset the drive controler? It seems to be a known problem, as there are some explanation on. Get an electronic board from a identical drive or directly alone. Through seatools the drive is showing 0 byte like in a dos boot and has a SN different from the one written onthe disk. Looking around I would say that the controler card went nuts and that the hard drive is fine. No bad treatment, was inside a tower and stopped working.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |